BE Appliances and CASO: SQL access error when making managed Server

Hi Bert,

 

Check and make sure that the BESA has the rights as listed under the CASO/SSO section below:

http://www.symantec.com/business/support/index?page=content&id=TECH130255#CASO-SSO

Thanks!

Hi Craig et al.

the account used is a full-blown domain admin (not stripped as some companies do), so I can't imagine any one of the rights missing...

The only thing a bit unusual is that the account used for the initial setup on the MBES was not correct, so it was changed later on (in effect to have the same account on the CASO and the MBES). Maybe that's the reason...?

Regards,

Bert

...maybe remove the MMS from the CASO and re-add it.

Thanks!

 

the problem occurs when I want to add the MMS after entering the CASO information, so it's not there to be removed...BTW: the customer confessed that the Admin is only a OU Admin, and not top level - can that be a reason?

It could very well be. Check the TN below on the rights required by the BESA to run properly:

http://www.symantec.com/business/support/index?page=content&id=TECH36718

Thanks!

 

Are there no takers for this problem? If not, then I guess nobody else ever had problems making one Appliance a Managed Server of a second Appliance that is defined as CAS?.

 

Well, this is the first bit of feedback since I posted the link above. There was nothing after that, hence no further help.

If that didn't help, I'd suggest logging a call with Symantec directly. Once they help you, please post back here and close it off.

Thanks!