Forum Discussion

Brian_Nordmann's avatar
Brian_Nordmann
Level 3
19 years ago

security issue: how data is written to tape

I have an issue where Security had to quarantine some of my tapes and now I have a restore to do from one of the tapes and I have to jump through some hoops.

Here is my question: can someone give me a general overview of how files are written to the tape? Specifically... is it possible for one non-confidential file to be "touching" a confidential file?

Or in other words - is there a specific "this file starts here and ends here" on tape or are files intertwined?
10.x and Earlier
Backup and Recovery
Backup Exec

3 Replies

Sort By
  • Ken_Putnam's avatar
    Ken_Putnam
    Level 6
    19 years ago
    Tape access sis strictly sequential. One file after another, but they are not different "files" on tape, they are one file in MTF (MicrosoftTapeFormat). Restore software reads the single big file and selects the data corresponding to one logical file based on "marks" in the bkf file

    I'm not sure where you are trying to go here. You cannot delete only one "file" from a tape or insert a file. You can only delete the entire BackupSet or append to the end of it.
  • Brian_Nordmann's avatar
    Brian_Nordmann
    Level 3
    19 years ago
    I am not trying to delete or append data to a tape. I am going to do a restore and have to be sure for our Security group that my file that I am restoring is not touching one of the confidential files.

    The Department of Defense is involved in this and they are a little picky!

    Your post was helpful though, thanks!
  • Ken_Putnam's avatar
    Ken_Putnam
    Level 6
    19 years ago
    OK -

    But if I may make a suggestion -

    If they are that picky about which files may or may not "touch" each other or be "next to" each other on tape, create separate backup jobs to separate tapes for the "secure" data, so in future you don't have to satisfy some security weenie just to do a restore for a regular user.