Issue of after replace a new LTO-5 Data Cartridge

Hi,

 

So you had one media called 3002L5, then it was faulty, so you removed it from the robot, took off the label and stuck it on a new media?

 

Is that what you did, or did i miss something?

Hi Riaan,

 

Many thanks for your reply and you are totally right !I have no idea that what should i do after replace the media.

 

I am sorry that i dont know too much of netbackup and still learning, please kindly advise when you have chance, thanks !!

 

Best Regards,

Kim

Hi Riaan,

Many thanks for your reply and you are totally right !I have no idea that what should i do after replace the media.

I am sorry that i dont know too much of netbackup and still learning, please kindly advise when you have chance, thanks !!

Best Regards,

Kim

Hi,

 

No problem, just wanted to make sure I know what you've done. 

 

Usually we'd not see customers replace media as you've done. If a media goes bad, whatever was on it would be lost, so no real benefit in putting the same label on it. In fact it might just confuse netbackup as it might expect to find the internal header 3002L5 written on the tape and it wont be there (netbackup writes a header on the tape that matches what the barcode says).

 

So, what we would usually do is, 

1. expire the images on the media, take it out, throw it in the bin, and replace it with a new media (new barcode too)
2. perform an inventory to recognise the new media

In your case you would need to check if there were any images on the media before it went bad.

 

bpimmedia -mediaid 3002L5

 

If there are images listed on that media they should have been written before the media went bad. PLease verify that and report back.

Thanks Riaan,

 

May I ask more details please ? 

1 How can I expire the media ? 2 how can I reissue the new label ?( I dont need to keep any old data  from that faulty media)

I really try to google it but it may casue by to easy to other people so no luck... please give me some advice , thanks again !!!!

Riaan gives good advice.

Robot load error can be mis-leading, it can have several causes

1.  The robot did not load the tape into the drive

2  The robot physicalled loaded the tape into the drive, but the drive did not sense it had a tape in it

3  The robot loaded the tape into the drive, the drive sensed it had a tape it but this confirmation never got to NetBackup - hence you still get a robot load error

One good thing to do (if possible, is to get someone to run the job whilst watching the library, does the tape actualy get moved into the drive or not,

We could also use robtest to do this, but as you are new to NBU, maybe just watching the library is going to be easier at this stage.

Hi Riaan,

 

Thanks again for your reply and i will try to following your suggestion !

Btw, i am using GUI admin console , is that also need to use the command line instead of GUI ?

If yes, i have to start to seach at Google to learn how to use these command....

 

Thanks !!~~~

 

Kim

After looking at your latest post, I found this post. There is honestly no way that you can walk into a new job with NO NBU experience or training and start to manage a busy environment with no sort of mentorship or senior 'go to' person. (Unless you were not 100% honest about your level of knowledge and experience.) You need to tell your management that you need training as a matter of urgency. In the meantime, find the Training section on Veritas.com and look for the free online training. In the meantime, download the NBU Admin Guide I and II (links to manuals and other docs in my signature) and start reading up about Devices and Media management. Good luck! PS: Please close off this discussion by marking Riaan's post as Solution.