Forum Discussion

Raz_Sam's avatar
Raz_Sam
Level 3
11 years ago

restore state is in pending for a long time.

Hi marrianne,

Now I am facing one restoration issue. When I am performing the restoration, the restore state is in pending for a long time.

In job Detailed Status, it is showing- awaiting resorce. But media is available in the library.

When I checked media status in command line, it is showing, Server Group=UNRESTRICTED_SHARING_GROUP"

For the above one, I have disabled "Enable unrestricted media sharing for all media servers" in Master server host properties.

I am very much worried about this issue and not able to find the actual cause.

For your information, I have performed Robotic Inventory also.

I will be thankful to you if you help me out in fixing this issue.

Thanks in advance,

Sam

 

 

5 Replies

  • Sam,

    If you change the disable "Enable unrestricted Media Sharing", I think it will effect to new backups not for existing backup,

     

    please checking the following,

    Check media reqired for the restore and then do filter in java gui--> media and check who is owning that tape...

     

    and also check

    FORCE_RESTORE option in bp.conf

     

     

  • Hi Sam,
     
    After how long the restore is being failed ?
    And what error code it is showing after failure ?
    Do the media server have free and up Drive for restore ?
     
    Regards,
    Vickie
  • Apart from the obvious things (tapes not in the library etc. which should all be shown in the text of the job itself) there are a couple of things that can cause this

    1. Master Server Host Properties - Fibre transport  - Default can be preferred - change to never of you dont use FT to speed things up

    2. Master Server Host Properties - General Server - Delay on mulltiplexed restore - this setting allows you to kick off multiple restores before any will start to run so that they can do multiple restores from a multiplexed tape - however every restore from a multiplexed tape will be affected by this setting so if you do not often do multiple restores at the same time reduce this setting.

    Changing these two can help - they do need a service re-start to register them

    Hope these help

  • Hi Vickie,

    Restore is not failing, it is in pending state for a long time.

    Yes, media server have free and up drive for restore.

     

    Thanks,

    Sam.