03-01-2016 01:31 PM
I attempted to install a clean installation of 3600 R2 on an existing appliance using the USB key.
The installation completed as expected, but it will not boot.
The display is black with a blinking cursor in the Left Upper corner.
Solved! Go to Solution.
03-02-2016 11:51 AM
Try to reinstall it as per the DR recovery procedure listed below:
https://www.veritas.com/support/en_US/article.HOWTO60836
Thanks!
03-02-2016 11:51 AM
Try to reinstall it as per the DR recovery procedure listed below:
https://www.veritas.com/support/en_US/article.HOWTO60836
Thanks!
03-21-2016 11:58 PM
Sounds like incorrect boot order.
Check the BIOS settings and the boot option should be set to use the Embedded RAID Controller (AHCI)
04-06-2016 08:18 AM
Thanks for the comments. I reset and verified BIOS setting - all is good.