cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Veritas.com
Support
Backup Exec 3600 Appliance

Discussion Posts

Start a discussion

Resolved! Backup Exec 2012 enhancements

Does anyone know if any of following have been addressed/implemented by BE 2012: Advanced disk backup option can handle DFS. ADBO allows one to carry out a weekly full and then daily incremental backups. Upon restore, BE works out which of the increm...

Exchange Archive?

  As far as I've read the Backup Exec Appliance does not support the Exchange Archiving Option for Backup Exec 2012. Does anyone know if they are looking at adding this support? Also, does anyone know the difference between the Exchange Archiving Opt...

Resolved! BackupExec GRT - AD and Exchange

Hi, I am setting up 2012 to backup my ESX servers. I can perform granular restore on all servers regarding individual files etc, but the applications side is not working. When I try to backup AD or Exchange I get the message "Backup Exec failed to ...

Client side dedupe for Linux machines

For all our linux machines, physical and virtual, we get the following when backing up: Client-side deduplication is enabled for this job, but it could not be used. The link points us to KB article V-79-18273.   I have tried following steps outlined ...

arctics by • Level 3
  • 474 Views
  • 4 replies
  • 1 kudos

Backup Exec - 3600 Interfaces

Hi, I have just installed the above appliance. I am experincing slow backup speeds (500MB/min) I have realised the traffic is going through interface connected to LAN. (connected via 100Mb switch) I have 2 interfaces connected direct to my GB iSCSI n...

BE 3600- blinking cursor

Installed new SSDs and proceed with the USB install process. The script finishes with the unti will shutdown. Take out the USB and reboot per the instructions and comes up to a blinking cursor so it never does finish the install process. Anyone seen ...

BE 3600 suggested backup selection

So we use a 3600 and the only information I have on what to back up to the off site tape was a small section in the admin guide, problem is there are not a lot of details and it really doesn't explain where the data is stored for the devices we backu...

Dedupe Services wont start, BackupExec Appliance

I need some assistance and I guess because of something internal at Symantec today I am unable to create a technical support case, so anyone who can assist me, I would be very thankful. We have a Backup Exec Appliance installed at a customer site, an...

Resolved! Concurrent Backups

Hi, just working on scheduling our backup jobs and note that by default, the be appliance 3600 R2 is configured to run 2 concurrent jobs.  Is this the max recommended for the appliance?  The BE 2012 admin guide doesn't provide specific recommendation...

arctics by • Level 3
  • 598 Views
  • 4 replies
  • 0 kudos

Resolved! Backup Exec 3600 - Blinking Cursor

Hello, New to the forums. I noticed today that with our Backup Exec 3600 (11.x) server that it is stuck at a BLACK SCREEN with a BLINKING CURSOR. I tried a reboot of the system, but it still gets stuck at this point. It was working on friday, and I d...

Which NAS Device to connect to a

I'm looking at upgrading our backup software. I'm interested in the following device, a Backup Exec 3600 Appliance and install this at the main site - SITE A. The problem is that I would replicate the data stored on that device to another connected s...