cancel
Showing results for 
Search instead for 
Did you mean: 

10d ran fine, upgraded to 11, speed sucks

Kent_Wyatt
Level 3
Hi!
 
I have been running v10d for quite a while and achieving backup speeds between 400mb to 2000mb.
 
I just upgraded to v11 and upgraded all the agents on all my servers and of course, the first job that runs is running at a horribly slow 15mb. So, at this rate my backup that took 14 hours on 10d will take probably 4 days on 11.
 
I have read and done all the standard checks that I've never actually heard worked for anyone -
 
I updated all drivers and firmware for all nics, disk controllers, tape devices, etc. I have set the NICs and switch ports to either 1gb full or 100mb full as supported.
 
My jobs ran on v10d at yesterday just fine. I upgrade to v11 and now the speed is ridiculous. I am brand new to v11 though, so did the upgrade and let it run. Is there anything else I need to or can do? Obviosly, I can't leave it at this rate.
 
Thanks for any help!
1 REPLY 1

GeekBoi_
Level 2
Hey Kent,
I'm having the same issue. I've just posted a msg about it. Have you found anything yet?
 
Cheers,
GeekBoi!