09-16-2010 01:52 AM
Hello,
suddenly the backup C2T-job is missing. This happens not regulary but often. If it happens I go in the Job Setup and Send the Job again.
Can anyone help?
Thanks
Katrin Rückbrod
09-16-2010 04:14 AM
Hi Katrin,
Not sure why that would happen. However, I would recommend patching with SP1 for BE 2010, and any available patches thereafter.
Post the results, and if it helped solve your issue, you can close off with the solution.
Thanks!
09-16-2010 04:53 AM
Check for the following in the backup job properties--schedule --start time and no later than time
Increase the time there and see if this helps,
I did not get what you mean By "C2T"???
09-17-2010 08:33 AM
Hello,
C2T means a Copy-to-Tape-Job. This is a job, that begins when the Backup to Disk ends.
I have SP1 installed and there are no other updates from Live Update.
I can't set any scheduler because this is a job that copy the data after an existing job.
Thanks
Katrin Rückbrod
09-17-2010 08:12 PM
If your C2T job is part of a B2D2T policy, delete all the jobs generated by the policy and then generate the jobs again.
09-21-2010 07:03 AM
Hello,
I don't use a policy.
Katrin
09-21-2010 07:56 AM
Does it allow you to create another C2t job for the same backup Job?
10-16-2010 11:20 PM
Hi Katrin,
Have you come right here?