Backup Exec 12.5 restore error

[zaxbg]

Hi Everyone,

When i was doing the last backup, i run a test restore after that and it blow with this error:

Error : e00084e7 - No data error reading from media. 

I am writing on a LTO4 Tandberg tapes. The verify goes ok. Only the restore job gets the error.

What should i do now?

- delete the last job and try to write it again iswhat i thik of.

Regards

[CraigV · Accepted solution]

Hi there,

Check the TN below...

http://www.symantec.com/business/support/index?page=content&id=TECH47604

there are a number of supplemental documents listed in the TN above which you might also want to double-check...

If you do a small backup to a B2D you can rule out hardware issues if it also fails. If it succeeds, then it could very well be your drive.

Thanks!