07-25-2011 04:34 AM
Hi Everyone,
When i was doing the last backup, i run a test restore after that and it blow with this error:
Error : e00084e7 - No data error reading from media.
I am writing on a LTO4 Tandberg tapes. The verify goes ok. Only the restore job gets the error.
What should i do now?
- delete the last job and try to write it again iswhat i thik of.
Regards
Solved! Go to Solution.
07-25-2011 04:56 AM
Hi there,
Check the TN below...
http://www.symantec.com/business/support/index?page=content&id=TECH47604
there are a number of supplemental documents listed in the TN above which you might also want to double-check...
If you do a small backup to a B2D you can rule out hardware issues if it also fails. If it succeeds, then it could very well be your drive.
Thanks!
07-25-2011 04:56 AM
Hi there,
Check the TN below...
http://www.symantec.com/business/support/index?page=content&id=TECH47604
there are a number of supplemental documents listed in the TN above which you might also want to double-check...
If you do a small backup to a B2D you can rule out hardware issues if it also fails. If it succeeds, then it could very well be your drive.
Thanks!