06-24-2015 02:02 AM
While I was verifying the tape,as depicted in the picture, there was an error. It stopped. Can we verify again? Do you know solution for my problem? Data is still on the disk.
06-24-2015 02:24 AM
Based on the above error, try the following:
1) Follow the steps as per this KB article - https://support.symantec.com/en_US/article.TECH83058.html
2) Update the NIC drivers on the BE media server and the remote server as well.
06-24-2015 07:36 AM
Yes, you can run a separate verify job, again & again. I am assuming htat this job has run multiple times before without error? If the verify fails multiple times, then I would assume the backup is bad and I would re-run the backup. If the verify passes, then it might have just been a momentary glitch during hte first verify.
06-24-2015 08:43 AM
How can i just verify i job ?
Regards.
06-24-2015 09:06 AM
Right click on the job history and select verify.
06-26-2015 12:47 AM
I’m verifying as you said but I get the error which is depicted in the Picture.How can I handle with this?And also the errors are not only in jobs with problem but in all jobs.
06-26-2015 12:59 AM
There was an issue with running manual verify in BE 2014. Would recommend to ensure BE 2014 is patched up with SP2 and run a verify along with the backup job itself.
06-26-2015 01:41 AM
installed update
06-26-2015 03:05 AM
it's updated but the problem continues
06-26-2015 05:10 AM
As mentioned earlier, you will have to run a verify along with the backup job itself.