cancel
Showing results for 
Search instead for 
Did you mean: 

Backup Exec problème VSS

Gillesdu75
Not applicable

Bonjour

J’ai un serveur Windows 2012 Datacenter avec 5 machine virtuelles, sur un autre serveur Windows 2012 Standard j’ai donc Backup Exec 15 pour sauvegarder mes machine virtuelles.

Le problème voici le message d’erreur :

Etat de fin du travail

Fin du travail : vendredi 7 août 2015 à 00:23:16

Etat de fin : Echec

Erreur finale : 0xe000fe1f - Le périphérique est introuvable.

Catégorie d'erreur finale : Erreurs des ressources

our plus d'informations sur cette erreur, reportez-vous au lien V-79-57344-65055

Erreurs

Cliquez sur une erreur ci-dessous pour la localiser dans le journal de  travail.

Sauvegarde -- xxxx.xxxx.com V-79-57344-65055 - Technologie de cliché : échec de lancement pour : "xxxx.xxxx.com\SAGEPAIE". Technologie de cliché utilisée : Non.

Erreur de la technologie de cliché (0xE000FE1F) : Le périphérique est introuvable

Je n’arrive pas à trouver la solution, j’ai fait des modifications dans la configuration des sauvegarde de backup exec au niveau des VSS mais toujours la même erreur

Pourriez-vous me venir en aide ?

Cordialement

 

Hello
I have a Windows 2012 Datacenter Server with 5 virtual machine on another Windows Server 2012 Standard so I Backup Exec 15 to back up my virtual machine.
The problem here is the error message:

State Job Completion
End of Work: Friday, August 7, 2015 at 0:23:16
State End: Failed
Final error: 0xe000fe1f - The device was not found.
Final error category: Resource Errors

For more information about this error, refer to link V-79-57344-65055

Errors
Click an error below to locate it in the job log.
Backup - xxxx.xxxx.com V-79-57344-65055 - Snapshot Technology: launch failure for: "xxxx.xxxx.com \ SAGEPAIE". Snapshot technology used: No.

Error of the snapshot technology (0xE000FE1F): The device was not found

I do not find the solution, I made changes in the configuration backup backup exec level VSS but still the same error

Could you help me?

Best regards
1 REPLY 1

VJware
Level 6
Employee Accredited Certified

Do ensure AOFO is enabled in the backup job and set to use the Microsoft VSS Provider.

Secondly, check the status of the VSS writers by running the vssadmin list writers command. If they are not in a stable state, reboot the server.

Also, check the event viewer for VSS errors/warnings.