Backup Failing V-79-8192-4881 - The count of Files and Directories processed is not available for this operation. The File and Directory count might be displayed as zero.

Hi everyone,

I am hoping that someone here has had this issue before and can help me out. I have been trying to figure out what is going on for a while with no luck.

Here is my setup:

Backup Source: NetApp (NetApp Release 8.1.3P1 7-Mode)
Backup Target: HP Autoloader 1/8 Tape Library
Backup Exec 2014 is installed on Windows Server 2008 R2 fully patched

I keep getting the following error on my backup jobs to the Tape Library:

Capture.jpg

I have another backup job that goes to a Synology NAS that is presented to Backup Exec as an iSCSI target that is working fine with no errors at all. 

Does anyone know what this could be caused by or how I could resolve this issue?

1 Solution

Accepted Solutions
Highlighted
Accepted Solution!

For anyone interested I was

For anyone interested I was able to get it sorted, it turned out to be my selections that was causing me the issue. Something had gone wrong in the selections so I redid them and everything is now working. The backup is also now 430GB rather then 145GB. 

View solution in original post

3 Replies
Highlighted

If "File History" is disabled

If "File History" is disabled in BE, then an information alert "The count of Files and Directories processed is not available for this operation. The File and Directory count might be displayed as zero." is shown which is expected. Enable File History & this message should go away, though i don't think this is an error.

Could you post the NDMP log instead or the complete job log itself ? Thanks.

Highlighted

Thanks for the response. File

Thanks for the response. File History was disabled so I have just re-enabled it and am running another job. If it "fails" again then I will post up the Log.

Highlighted
Accepted Solution!

For anyone interested I was

For anyone interested I was able to get it sorted, it turned out to be my selections that was causing me the issue. Something had gone wrong in the selections so I redid them and everything is now working. The backup is also now 430GB rather then 145GB. 

View solution in original post