08-10-2010 04:10 AM
Running BE2010 Trial on Windows Server 2008 R2 x64. Hardware is Dell R710 rack server, connected to a HP Ultrium 1760 LTO4 SAS drive via a Dell PERC 6/E SAS Adaptor card.
This is what’s happening:
I’ve completely replaced:
We’ve verified that all above component drivers and firmware are fully up to date. This problem occurs with both Symantec Tape Drive drivers and HP's official LTO4 tape drivers,
To me, the following facts suggest that the problem lies with BackupExec itself:
Solved! Go to Solution.
08-18-2010 01:07 AM
08-18-2010 02:48 AM
08-18-2010 03:05 AM
08-18-2010 03:30 AM
08-18-2010 03:48 AM
08-18-2010 05:25 AM
08-18-2010 08:29 AM
08-19-2010 12:26 AM
08-23-2010 12:39 AM
08-23-2010 03:08 PM
08-24-2010 03:24 AM
08-24-2010 05:18 AM
08-24-2010 09:59 AM
08-24-2010 08:45 PM
09-07-2010 07:43 AM
09-19-2010 06:16 AM
We fitted the Perc 5/E and we have have resolved the issue.
09-24-2010 01:41 AM
Larry,
Apologies for the delay in my reply, I have been fully allocated to project work, and have literally just found time to install a Dell 6gbps SAS HBA board into the R710.
Ran a few tests, and pleased to say everything is now working as expected. As an added bonus, I've seen the job rates rise up to 8,400MB/min (according to BE anyway).
Thanks for your assistance.
Regards,
Alistair
09-24-2010 01:58 AM
Alistair,
You should mark one of Larry's reply as the solution and close out this discussion.
09-24-2010 02:04 AM
phk,
As far as I can tell, Larry's comment has already been marked as a solution.
09-24-2010 02:08 AM
I think I posted my comment just as you were marking it. Never mind.