02-28-2011 05:53 AM
Hello,
Can I tell a backup 2010 job what Nic to use on the backup server?
Thanks
02-28-2011 06:08 AM
Yes, Select the NIC in the JOB properties
02-28-2011 06:08 AM
tools - option - n/w and security and select interface there to select your LAN
02-28-2011 06:21 AM
This seems to be global, can I select this for a single job only?
02-28-2011 06:25 AM
You can also select it per job basis.
02-28-2011 12:21 PM
I don't get these options per job, all it shows is what encryption I should use.
02-28-2011 05:57 PM
No. You do get to choose the NIC. See below
If your job is a duplicate job, then you cannot choose the NIC because it is not applicable.
03-01-2011 12:30 PM
Strange I'm just editing a normal job and dont get those extra options
03-01-2011 12:57 PM
can you post a screenshot of your job settings ?
03-12-2011 04:47 AM
sure,
03-12-2011 04:08 PM
I think this needs to be feature enhancement. I'm using dedupe and boy would it be nice to put each server on it's own nic. I also do dedupe and tape at the same time and boy it would be nice to have server going directly to one nic etc.
03-12-2011 05:06 PM
I think your server is a managed media server. You would need to check the last option on this page "Allow managed media server to use any network interface to access remote agents"
03-12-2011 06:29 PM
I just changed that option and fired up a 2nd job and it does use that 2nd nic.
03-13-2011 12:00 AM
Just selected that option on an existing job and don't get the option of what nic to use.