01-07-2015 08:12 AM
Is there a way to disable Auto-eject? I maintain a BackupExec 2013 Server remotely using a Dell RD1000 cartridge drive, and whenever BE has an issue with a media (whether it is full, read-only), I cannot proceed to fix the problem unless somebody on-site goes to the server and puts the media back in. This is usually a pain (and reduces customer confidence in the system). So, I would like the option to tell BE to issue any alerts it wants, and stop in mid-stream if it has to, but leave the cartridge in place until I tell it to eject. I would be happiest with a global option setting, but if there is an option within the backup job definition itself, that might be OK.
TIA,
Peter
Solved! Go to Solution.
01-07-2015 11:27 AM
Hi,
Don't think this is possible as it seems to be the default behaviour.
Here is a link to the Idea to get this put into a future release of BE, so go vote it up and add your voice to the bottom of the comments section.
https://www-secure.symantec.com/connect/ideas/stop-default-tape-eject-behaviour-be-2012
Thanks!
01-07-2015 11:27 AM
Hi,
Don't think this is possible as it seems to be the default behaviour.
Here is a link to the Idea to get this put into a future release of BE, so go vote it up and add your voice to the bottom of the comments section.
https://www-secure.symantec.com/connect/ideas/stop-default-tape-eject-behaviour-be-2012
Thanks!