07-18-2013 11:03 PM
we use exec12.1.
Job ended: Thursday, July 18, 2013 at 12:19:09 AM
Completed status: Failed
Final error: 0xe00084ec - A tape read/write error has occurred. This is usually caused by dirty read/write heads in the tape drive. Clean the tape drive, and then try the job again. If the problem persists, try a different tape. You may also need to check for problems with cables, termination, or other hardware issues.
Final error category: Backup Media Errors
I checked the library and clean drive agian . but still not wroks.
how can I do ??
Thanks a lot
07-18-2013 11:13 PM
Hi,
Get hold of your tape drive manufacturer's diagnostic utility for tape (HP have HP LTT for instance). Stop the BE services, and run a diagnostic test against the drive to rule out hardware issues.
You can also run a cleaning job against the drive using the utility which will also report whether or not the cleaning process is working.
Thanks!
07-18-2013 11:25 PM
hi
could you send me the menthrod of operating step?
thanks
07-18-2013 11:46 PM
I don't know what type of hardware you have, but check below:
1. Download the drive utility from the manufacturer's site;
2. Stop the BE services;
3. Run a "health" diagnostic against the drive. If it brings up hardware issues, replace the drive;
4. Run a cleaning job from the utility;
5. Start up the BE services and try running a job again.
Thanks!
07-19-2013 12:09 AM
When you run the diagnostic test as previously advised, make sure you select the write test.
If you tape drive passes the diagnostic test and still asked to be cleaned despite being recently cleaned, then the tape drive needs to be replaced because it is faulty.
07-19-2013 07:45 AM
07-20-2013 02:59 AM
Hi,
This cause your media\Drive having some problem. Do the below steps...
- Take the tape from library
- Clean your library using clean tape
- Power off your library and again Power on it
- Now insert a different tape and run a test job... If it's running without any issue and insert the old tape and run a job...
-vicky
"Mark as solution if your issue got resolved"
07-20-2013 03:09 AM
Why are you repeating what has been said earlier?
07-20-2013 06:06 PM
07-20-2013 06:10 PM
07-20-2013 06:21 PM
If you forget something, edit your previous post and add it in. Don't post multiple times.