I am having some trouble understanding how to set up GRT for Exchange 2010. So far I read and re-read the BE Admin guide and I seem to be stuck at the point of adding the DC or DAG Group server name. To be clear, with only one Exchange 2010 server, are you still able to specify the DAG server group name? It looks like I can but then...
Once I put in the name for exchange 2010 server, let BE go off and locate it, I then refresh the page and I see an object ESEFS_DAG::\\E2K10. When I try to browse its contents, I get an error of 'An invalid device was specified'.
Not really sure what is happening with that.
Would anyone have had this experience?
Thanks in advance for any and all replies.
You have mentioned that you have only one Exchange 2010 server which suggest that Exchange is not in DAG configuration.
In the backup selection list you will still be able to see the option to Add DAG group name. But need not worry over here as this option is not valid since Exchange is not in cluster. So do not add any DAG name or Exchange servername in this node.
Make sure you have installed Backup Exec Remote Agent on the Exchange 2010 server. Then in the selection list under Favourites resources you will be able to see the Exchange server listed under Windows server node. Expand the Exchange server and you will be able to see the Microsoft Information Store for Exchange. Select this for the backups and you should be good. GRT option is by default enabled for Exchange backups.
I have used the agent and followed along with the Wizard which has a 'guide me' section. Now, we did not use a policy as we only do full backups. Does GRT actually work with full back jobs? In testing here is what we found:
Here are setting for the Exchange backup:
|Backup method:||Full - Database & Logs (flush committed logs)|
|Backup method:||Full - Back up messages - Reset archive bit|
Continuously back up transaction logs with Backup Exec Continuous Protection Server: No
Is there anything in that I should closely look into?
Thanks in advance,
Yes. GRT works well with Full backup of Exchange. What i could think which is missing from here could be the updates. Make sure that Backup Exec is fully patched with latest Service packs and Hot fixes (You may have to run Live updates number of times till its fully patched). Ones the Media server is updated then push install the remote agent again to the remote Exchange server and it will update the Remote Agent too.
Now test the backups and restore and see the result.
Also if your backups are on tapes then during the restore it will stage the Information store at the temporary location on the Media server. By default this location is C:\TEMP. You can change the location for staging if there is any issue of less disk space on the C: drive. In the Restore job go to Advanced tab where you will get the option to change the Staging location.