Highlighted

V-79-57344-33234 - Für diesen Auftrag wurde nichts ausgewählt.

Hallo Zusammen,

kurz die Fakten:

- Die B2D Sicherung fand um 00:00 - 03:47 Uhr statt.

- Die B2T Sicherung fand von um 03:11 Uhr statt, obwohl die Dublizierung nacheinander erfolgen soll, laut Regel "Alle geplanten Backup-Sätze dublizieren, die mit B2D... erzeugt wurden.

1. Fehler: Die Sicherung war erst um 03:47 fertig, um 03:11 wurde aber schon gestartet. Wie kann das passieren?

2. Fehler: V-79-57344-33234 - Für diesen Auftrag wurde nichts ausgewählt. Wenn ich den Auftrag wiederhole, ist der Datensatz richtig ausgewählt und vorhanden (Rechtsklick auf Auftrag: Auswahlliste bearbeiten, Auswahldetails anzeigen). Also alles ok.

 

Hat hier jemand ähnliche Erfahrungen?

PS: Die Zeitfenster für die Aufträge sind für B2D von 00:00 - 24 Uhr, für B2T von 03:00 - 24 Uhr.

1 Solution

Accepted Solutions
Accepted Solution!

Hi,   Are you saying that

Hi,

 

Are you saying that although your job started at 3:11AM it only completed at 3:47AM? what are you backing up, and how big is your data that you are backing up?

Your selection list order should dictate how your selections are backed up, and I have seen this already in the forum this past week. However, that OP seemed happy that his data was being backed up. You can always try creating another selection list and setting the order there before assigning it to your backup job. If it works the way you want it too, trash the old selection list and use this 1.

Thanks!

View solution in original post

1 Reply
Accepted Solution!

Hi,   Are you saying that

Hi,

 

Are you saying that although your job started at 3:11AM it only completed at 3:47AM? what are you backing up, and how big is your data that you are backing up?

Your selection list order should dictate how your selections are backed up, and I have seen this already in the forum this past week. However, that OP seemed happy that his data was being backed up. You can always try creating another selection list and setting the order there before assigning it to your backup job. If it works the way you want it too, trash the old selection list and use this 1.

Thanks!

View solution in original post