cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted

Why Job Completed status: Completed with exceptions

Wgy Job Completed status: Completed with exceptions ?

 

The job log as attached.

4 Replies
Highlighted

Re: Why Job Completed status: Completed with exceptions

@sy_nattapon 

Did you see this?

The job has been configured for either data encryption or software compression, or both. 
The job is also targeted to a device that is capable of data deduplication. 
Encryption and compression of the backup data can prevent much of the data from being deduplicated.
Highlighted

Re: Why Job Completed status: Completed with exceptions

Hello Marianne,

Than ks for your reply.

I have seen it. but, I'm not understand.

I don't know that what's job hs been exeption or what's job has been completed. 

Highlighted

Re: Why Job Completed status: Completed with exceptions

The job log tells me that the job has completed  (there are similar stats for databases and System state): 

Backed up 125219 files in 3623 directories.
Processed 13,010,471,599 bytes in  13 minutes and  38 seconds.
Throughput rate: 910 MB/min
Compression Type: Software
Software compression ratio: 2:1

 

but with VERY low dedupe rate (5.7%)  :

Deduplication Stats::PDDO Stats for (BACKUP-SRV1): scanned: 176983320 KB, CR sent: 166825813 KB, 
CR sent over FC: 0 KB, dedup: 5.7%, cache hits: 92228 (5.4%)

 

The 'exception' is a warning to tell you about about it. 

You should not enable compression on a job that goes to dedupe storage. 
See BE Admin Guide for details.
You are wasting your dedupe storage and will fill it up way too soon. 

Highlighted

Re: Why Job Completed status: Completed with exceptions

Hello Marianne,

Thank so much for your help.

The reason that I enable compression on a job is I want to solv the system state failure as solution below.

https://www.veritas.com/support/en_US/article.100033965

I try to find more solution for fix the system state failure but I cannot fix.