09-17-2012 05:13 AM
I have a customer using Backup Exec 2012, They have been using 2010 but the scripts need to be deleted and re-created.
I am doing this without any problems, but when it comes to selecting the destination I cannot select the iSCSI drive S:
I have tried connecting to the servers sharepoint aswell but get a Authentication error.
How can I configure an iSCSI backup location?
Solved! Go to Solution.
09-17-2012 05:45 AM
Hi,
You'd obviously carve out your iSCSI storage and present to your server, formatting it and giving it a drive letter. THis is what you have done already.
See if you can create a folder on the S:\ drive through Windows, and then add this as a storage location within BE.
If need-be, unpresent, and then present the S:\ drive again.
THanks!
09-17-2012 05:45 AM
Hi,
You'd obviously carve out your iSCSI storage and present to your server, formatting it and giving it a drive letter. THis is what you have done already.
See if you can create a folder on the S:\ drive through Windows, and then add this as a storage location within BE.
If need-be, unpresent, and then present the S:\ drive again.
THanks!
09-17-2012 06:04 AM
Hi CraigV
I have disconnected and reconnected the iSCSI drive but Backup Exec cannot see the drive.
I take it I would be adding this under Disk-Based Storage and then selecting Disk Storage
09-26-2012 05:15 AM
Sorry for only replying now, but when you want to add a B2D folder to BE you'd use Disk-Based Storage.
To remove the LUN itself you would do this through the iSCSI initiator.