cancel
Showing results for 
Search instead for 
Did you mean: 

Bonding VCS

99cassano
Level 3

Hi,

I want to reconfigure my clusters so that it runs on bonding mode. The cluster was running only running on specific eth on public facing network. But now since the servers have configured bonding using two eth interfaces, any procedure to follow to change the vcs configuration to use the bonding pairs?

 

Thanks 

1 ACCEPTED SOLUTION

Accepted Solutions

Gaurav_S
Moderator
Moderator
   VIP    Certified

Hello,

You have two choices, configuring a bonded interface within a service group & then creating proxy resources in other service groups to point to this bonded resource  OR configure a parallel service group only containing NIC resources (bonded) & a phantom resource to monitor the same. All other service groups will have proxy resources pointing to this bonded resource.

typical configuration can be read here

https://sort.symantec.com/public/documents/sfha/6.1/linux/productguides/html/vcs_bundled_agents/ch03s03s03.htm

 


G

View solution in original post

1 REPLY 1

Gaurav_S
Moderator
Moderator
   VIP    Certified

Hello,

You have two choices, configuring a bonded interface within a service group & then creating proxy resources in other service groups to point to this bonded resource  OR configure a parallel service group only containing NIC resources (bonded) & a phantom resource to monitor the same. All other service groups will have proxy resources pointing to this bonded resource.

typical configuration can be read here

https://sort.symantec.com/public/documents/sfha/6.1/linux/productguides/html/vcs_bundled_agents/ch03s03s03.htm

 


G