Problem with bonding and VCS

[Antonio_Santiag]

Hi,
I have installed recently a new 3-node cluster . VCS MP3 on RHEL 5.4 . 
I have serious problem when I start gab service . Just after start the service I lost connection through bond0 (public network).

Content of /etc/llttab

set-node node-test
set-cluster 10
link bond2 eth-00:15:17:bf:80:b7 - ether - -
link-lowpri bond0 eth-00:15:17:bf:80:b5 - ether - -

cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.4.0 (October 7, 2008)

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth2
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0

Slave Interface: eth2
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:15:17:bf:80:b5

Slave Interface: eth9
MII Status: up
Link Failure Count: 0
Permanent HW addr: 00:15:17:bf:87:86

In the switch I see mac flapping between the two interfaces. Clearly there's a problem with the low-priority configuration in bond0, but I can't see anything.

Any help?

Thanks.

[Gaurav_S]

Hello,

Not sure of the problem at this stage... one simple question though... I see from the config that you have just configured one high pri link & one low pri link ?

VCS should be good with 2 links atleast otherwise you will constantly see a jeopardy state on GAB..

I would suggest to keep to  try with keeping 2 high pri links & then one low pri link..


Gaurav