cancel
Showing results for 
Search instead for 
Did you mean: 

how to add GCO function after the cluster installed and running

hejohn
Level 2

Hi There,

am wondering if anyone can help on how to can add GCO function after the cluster installed completed and i have the cluster already running for a while. please. thanks.

Kind Regards,

John

1 ACCEPTED SOLUTION

Accepted Solutions

Gaurav_S
Moderator
Moderator
   VIP    Certified

Hi John,

You don't need to install any new component or software to get GCO to work.

Ideally you should have VVR replication  setup between two sites & you should have VVR & GCO license for operation. You can go keyless (demo license for 60 days) but you would finally need license for all this to work together.

Below section would help you

https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_admin/pt05.htm

 

G

View solution in original post

5 REPLIES 5

Gaurav_S
Moderator
Moderator
   VIP    Certified

Hi John,

You don't need to install any new component or software to get GCO to work.

Ideally you should have VVR replication  setup between two sites & you should have VVR & GCO license for operation. You can go keyless (demo license for 60 days) but you would finally need license for all this to work together.

Below section would help you

https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_admin/pt05.htm

 

G

View solution in original post

hejohn
Level 2

Thanks Gaurav,

        just want to confirm that if during my initial installation i didn't click the yes to include the GCO function, in that case i still can use the geo cluster function or?

Kind Regards,

John

Gaurav_S
Moderator
Moderator
   VIP    Certified

Hi John,

You should be able to still use to GCO function. If you look at manual installation procedure in below mentioned link, there is no separate package that gets installed for GCO purpose

https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_install/ch16s02s02.htm

https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_install/apbs01.htm

I am not too sure but I would expect that once you say "y" to install the GCO component during installation procedure, VCS would enable the setup of Wide Area Connector (WAC) resource.

 

G

 

hejohn
Level 2

Thanks Gaurav,

It's ok now, i've updated the keyless product level to reach the GCO function now. thanks again for your  help Gaurav.

Kind Regards,

John

 

rsharma1
Level 5
Employee Accredited Certified

you can execute '/opt/VRTSvcs/bin/gcoconfig' post installation to configure GCO between the VCS clusters