10-01-2014 07:38 PM
Hi There,
am wondering if anyone can help on how to can add GCO function after the cluster installed completed and i have the cluster already running for a while. please. thanks.
Kind Regards,
John
Solved! Go to Solution.
10-01-2014 07:55 PM
Hi John,
You don't need to install any new component or software to get GCO to work.
Ideally you should have VVR replication setup between two sites & you should have VVR & GCO license for operation. You can go keyless (demo license for 60 days) but you would finally need license for all this to work together.
Below section would help you
https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_admin/pt05.htm
G
10-01-2014 07:55 PM
Hi John,
You don't need to install any new component or software to get GCO to work.
Ideally you should have VVR replication setup between two sites & you should have VVR & GCO license for operation. You can go keyless (demo license for 60 days) but you would finally need license for all this to work together.
Below section would help you
https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_admin/pt05.htm
G
10-01-2014 08:11 PM
Thanks Gaurav,
just want to confirm that if during my initial installation i didn't click the yes to include the GCO function, in that case i still can use the geo cluster function or?
Kind Regards,
John
10-01-2014 08:35 PM
Hi John,
You should be able to still use to GCO function. If you look at manual installation procedure in below mentioned link, there is no separate package that gets installed for GCO purpose
https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_install/ch16s02s02.htm
https://sort.symantec.com/public/documents/sfha/6.1/solaris/productguides/html/vcs_install/apbs01.htm
I am not too sure but I would expect that once you say "y" to install the GCO component during installation procedure, VCS would enable the setup of Wide Area Connector (WAC) resource.
G
10-01-2014 08:40 PM
Thanks Gaurav,
It's ok now, i've updated the keyless product level to reach the GCO function now. thanks again for your help Gaurav.
Kind Regards,
John
10-01-2014 09:46 PM
you can execute '/opt/VRTSvcs/bin/gcoconfig' post installation to configure GCO between the VCS clusters