10-30-2013 06:25 AM
Just reading Upgrade instructions for 10.0.4. On page 34 it states;
Accelerator or Discovery Accelerator
If the Enterprise Vault environment that you are upgrading includes Compliance
Accelerator or Discovery Accelerator, the Accelerator version must be upgraded
to 10.0.4 or later. The Accelerator version can be up to one major version higher
than Enterprise Vault, but it must not be lower than the version of Enterprise
Vault.
See the Enterprise Vault Compatibility Charts at
http://www.symantec.com/docs/TECH38537.
You must upgrade the Accelerator product before you upgrade Enterprise Vault.
Perform the upgrades in the following order:
This is a change from previous upgrades, where you had to upgrade EV first, then EV components on DA server and then DA itself. Can anyone confirm? Anyone did DA 10.0.4 upgrade yet?
Solved! Go to Solution.
10-30-2013 06:57 AM
Hi Mike,
No. This is not for only 10.0.4.
Perform the upgrades in the following order:
10-30-2013 06:42 AM
Hi Mike,
The Upgrade of DA / CA in EV environment has same order as describe above.:
Perform the upgrades in the following order:
The DA Version should be and always equal or higher than current version of EV.
If you first upgrade EV and then upgrade EV on Accelerator Server and then try to upgrade DA, it will fail at the time of DA Configuration.
You can also refer following article :
Supported upgrade paths for Enterprise Vault (EV), Compliance Accelerator (CA), and Discovery Accelerator (DA).
http://www.symantec.com/docs/TECH53174
10-30-2013 06:45 AM
Thanks, is this new for 10.0.4?
10-30-2013 06:56 AM
No. The requirement to upgrade the Accelerator product first and for it to be equal to or greater than EV has been in place since 8.0 SP3.
10-30-2013 06:57 AM
Hi Mike,
No. This is not for only 10.0.4.
Perform the upgrades in the following order:
10-30-2013 07:34 AM
Hi Mike,
Thanks for marking as solution.