05-12-2017 12:48 AM
Hi
Does anyone know any way to change the IP address list on the Connection tab of the configuration of a partition that stores data in Centera using the command line?
Best regards.
Solved! Go to Solution.
05-12-2017 07:22 AM
Gertjan is right that you can do this in SQL. EnterpriseVaultDirectory database, PartitionEntry table, IPAddressList column. Multiple addresses in a list should be separated by a comma.
I'm not sure if you literally want to do it from the cmd prompt or if that was just a gloss for "do it in bulk without having to click a lot," but if the former, then sqlcmd is a way to run SQL statements from the cmd prompt.
--Chris
05-12-2017 05:28 AM
Hello,
I don't think you can. You might be able to do it in SQL, but that will be not supported.
05-12-2017 07:22 AM
Gertjan is right that you can do this in SQL. EnterpriseVaultDirectory database, PartitionEntry table, IPAddressList column. Multiple addresses in a list should be separated by a comma.
I'm not sure if you literally want to do it from the cmd prompt or if that was just a gloss for "do it in bulk without having to click a lot," but if the former, then sqlcmd is a way to run SQL statements from the cmd prompt.
--Chris
05-23-2017 12:02 AM
Great... Thank you and best regards.