02-14-2014 03:20 AM
Hi Team,
I'd like to know if you have experienced any known issues upgrading old 5200 2.0.1 Appliance media server to 2.5.4.
While I do not expect any major problems groing from 2.5 to 2.5.4, I am not too sure from 2.0.1 to 2.5.
What are you thoughts ?
Thanks
Francesco
Solved! Go to Solution.
02-17-2014 02:10 AM
The original 2.5 patches were faulty and were withdrawn - the current one available should be OK but obviously there always can be issue crop up like the one you linked to.
http://www.symantec.com/docs/TECH198449 does indicate you can go straight from 2.0.x to this release.
So you should be OK, especially if it is just a Media Server
02-14-2014 07:34 AM
2.0.1 to 2.5 is not too bad but if it is a Master Server you will need to have 2.5.4 ready and uploaded to it before you start as 2.5 totally disabled NetBackup until 2.5.x has been applied.
Also work through the late breaking news section to make sure you also have any EEBs to hand that you may want to install http://www.symantec.com/docs/TECH145136
Hope this helps
02-16-2014 11:21 PM
Hi Mark,
I just recall some consultants saying that it was not possible to upgrade from 2.0.1 to 2.5 simply because the upgrade did not work.
So far, this is the only TN I found.
Thanks,
Francesco
02-17-2014 02:10 AM
The original 2.5 patches were faulty and were withdrawn - the current one available should be OK but obviously there always can be issue crop up like the one you linked to.
http://www.symantec.com/docs/TECH198449 does indicate you can go straight from 2.0.x to this release.
So you should be OK, especially if it is just a Media Server