11-21-2014 07:21 AM
Hello All
NBU appliance 5220 at version 2.5 NBU 7.5.
zoning is all done at switch level. aliases created as per WWN. zones created for robot , tape drives and appliance HBA.
But NBU appliance unable to detect overland tape library and robots. Scan command only shows tape drives not robots.
plz suggest
Solved! Go to Solution.
11-21-2014 12:14 PM
If zoned correctly and supported, it should be Seen.
First off make sure that your overland library is listed on the 7.6 HCL for Overland.
Then check out this thread post by sazz that goes over the steps: HOW TO - configure a SAN based Tape Drive and Libr on a 5220 Appliance
11-21-2014 12:14 PM
If zoned correctly and supported, it should be Seen.
First off make sure that your overland library is listed on the 7.6 HCL for Overland.
Then check out this thread post by sazz that goes over the steps: HOW TO - configure a SAN based Tape Drive and Libr on a 5220 Appliance