Netbackup Appliance 5330 2.7.3 FTMS hba in Initiator mode

[albatroz19]

Hi all,

I think that there could be a misconfig on appliance, because i saw that the hba port reserved for FTMS service, are configured in Target mode, but the physycal state it's in initiator mode.

Appliance Model is NetBackup Appliance 5330.
Appliance Version is 2.7.3.
Appliance is configured as media server.

**** Ports ****
Bus ID Slot Port Port WWN Status Physical State Configuration Type Speed Remote Ports
09:00.0 Slot5 1 21:00:00:24:FF:3C:12:E6 Online Initiator Target(FTMS) 8 gbit/s
09:00.1 Slot5 2 21:00:00:24:FF:3C:12:E7 Online Initiator Target(FTMS) 8 gbit/s

0a:00.0 Slot6 1 21:00:00:24:FF:3C:15:04 Online Initiator Target(FTMS) 8 gbit/s
0a:00.1 Slot6 2 21:00:00:24:FF:3C:15:05 Online Initiator Target(FTMS) 4 gbit/s

It's normal?
How can set the physical state in target mode, because on master server, the media server it's active for FT transport, but FT state it's Not Active.

Thanks in advance,
Best Regards

[albatroz19 · Accepted solution]

Hi all,

at last, we performed the -nbhba command and repeated the appliance configuration for FT services, and reboted it.

Then, appliance rebooted with correct status.

Regards,