PD Installation Error: PureDisk 6.5.0.1 is not supported ,install PD 6.5.0.3?

[Mohammad_Ahmad]

One of our client is installing PureDisk 6.5 Operatin System and while installing it gives error that Puredisk 6.5.0.1 is remote office edition and not supported ,,install PureDisk 6.5.0.3 

i am really confused , tha which step i have missed

i have mounted   PureDisk Application label ISO file and ran the command

# sh /cdrom/puredisk/software/install.sh

and got the error that PD 6.5.0.1 is not supported , it is remote office edition,  

install PD 6.5.0.3 .

i am following the guide also

[inn_kam · Accepted solution]

after mounting the PD OS iso file

Type the following command to run the post-installation script.

# sh /cdrom/pdextras/pdos-postinstall.sh

then dismount it 

and again mount PD Application Server Std Client iso file 

and reran the installation file

# sh /cdrom/puredisk/software/install.sh

Hope it helps

[Mohammad_Ahmad]

oh yes i was missing this step, and now installation works

i am also watching PD Storage pool guide and it is also mentioned there , but i have missed it

Completing a Manual installation

The following procedure explains how to complete a Manual installation.

To complete Manual installation

1 Type commands to mount the CD-ROM.

For example:

# mkdir /cdrom

# mount /dev/cdrom /cdrom

On a few hardware platforms, the CD ROM device /dev/cdrom is not

available by default. If you cannot find /dev/cdrom, refer to the following

section:

“Troubleshooting the cdrom device” on page 222

2 Type the following command to run the post-installation script.

# sh /cdrom/pdextras/pdos-postinstall.sh

This command might return some VxVM startup failure messages. You can

disregard them.

3 Unmount and eject the CD-ROM.

For example:

# umount /cdrom

# eject

4 Remove the PDOS disk from the CD-ROM drive.

5 Proceed to the following section:

“Verifying the installation” on page 76

( taken from PD6.5 Storagepool install guide page no.75)