cancel
Showing results for 
Search instead for 
Did you mean: 

BMR Restore on Windows 2016 Server

Aurelien59
Level 4

Hi everyone,

I am trying to perform a BMR Restore on a Windows 2016 server, using a newly created SRT (then ISO on USB) BMR boot server is running on Windows Server 2008 R2, and Netbackup Version is 8.0).

Restore is done on the same server that I backed up successfully. 

I boot on BMR USB key successfully, I enter TCP/IP settings, then I confirm which image I want to restore, and then start restore operations. But I got an error at first step after settings TCP/IP parameters. It opens a specific window for map/unmap disks etc. Or sometimes I got a popup error "Could not initialize configuration, Error Code = 1" 

In this window, in "original" there are all disk and volumes with C: partition "Boot", but in "new" I can only see the USB key. 

"Diskpart> list disk" shows only USB key too.

Is there any prerequisites I should deal with to get a proper running BMR restore ? (BIOS/UEFI config ? Secure Boot ? ..)

I attached bmrrst.log

1 ACCEPTED SOLUTION

Accepted Solutions

Michal_Mikulik1
Moderator
Moderator
Partner    VIP    Accredited Certified

Hello,

BMR on Windows 2016 support starts at NBU 8.1.1 See page 44 here: https://www.veritas.com/content/support/en_US/doc/NB_80_OSSCL

Regards

Michal

View solution in original post

1 REPLY 1

Michal_Mikulik1
Moderator
Moderator
Partner    VIP    Accredited Certified

Hello,

BMR on Windows 2016 support starts at NBU 8.1.1 See page 44 here: https://www.veritas.com/content/support/en_US/doc/NB_80_OSSCL

Regards

Michal