03-30-2012 12:05 AM
Hi All,
According to NetBackup Vault operators's guide:
*********************************************************************
Caution: If media are not removed and a time out condition occurs, the media are
returned to (injected into) the library slots in the robot.
If a time out occurs, you should inventory the robot as described in the chapter
about management of media in robots in the NetBackup Administrator’s Guide.
*********************************************************************
I would like to how how can i change the timeout value in NetBackup?
Thanks!
03-30-2012 01:08 AM
Found this TN: http://www.symantec.com/docs/TECH163557
Add a directive to the /usr/openv/volmgr/vm.conf file on the robot control host, and restart MM daemons for the change to take effect. The directive is
MAP_CONTINUE_TIMEOUT = <timeout in seconds>
For example, to set the amount of time to remove tapes from the MAP to 15 minutes, add the directive
MAP_CONTINUE_TIMEOUT = 900
and restart MM processes on the robot control host.
03-30-2012 01:37 AM
Removed my reply as I was wrong as Mariaane was right ...
Seems a feature that sneaked in at 7.x that I dodn't know about - ...
Regards,
Martin
03-30-2012 02:34 AM
Thanks a lot! I will try this