11-20-2013 06:18 AM
Hi,
Although I've done the cleaning robots, when I run the command tpclean.exe -L, says it needs cleaning. Also on netbackup Administrator console, I see it has been used 0 times. Even in drve tells me that cleaning is not necessary.
The result is that at regular intervals to have alert that needs cleaning and stop the backup. Any help????
* The cleaning tape is new
Solved! Go to Solution.
11-20-2013 06:58 AM
That means NetBackup will not use the drive until it has been cleaned
You need to put the cleaning tape in the library so that NetBackup can use it when it needs to - it only takes a minute or so and should not cause any backups to fail as a result
I would usually advise to keep 2 cleaning tapes in a library so that you always have one available.
Without one NBU will simply not use that drive again until it sees it has been cleaned
11-20-2013 06:41 AM
So, your cleaning tape is NOT in the robot? (Robot Type = NONE)
You can reset cleaning on the drives with:
tpclean -M <drive_name>
11-20-2013 06:43 AM
as per capture 1, there is no cleaning frequency set.
does your backup activity are intrupeting with Cleaning flag?
11-20-2013 06:45 AM
yes
11-20-2013 06:47 AM
what is the flag that you are reciving...
could you show us the compleate log?
11-20-2013 06:50 AM
I run this command and what; Is this a solution;
11-20-2013 06:52 AM
"the device has indicate yhat cleaning is required before further operations are attempted. (1165)"
11-20-2013 06:58 AM
That means NetBackup will not use the drive until it has been cleaned
You need to put the cleaning tape in the library so that NetBackup can use it when it needs to - it only takes a minute or so and should not cause any backups to fail as a result
I would usually advise to keep 2 cleaning tapes in a library so that you always have one available.
Without one NBU will simply not use that drive again until it sees it has been cleaned
11-20-2013 07:03 AM
After the reseting, it seems to be ok, but the "mounts" of the cleaning tape in the Administrator console, still 0
11-20-2013 07:05 AM
Because you have cleaned the drives manually, NBU does not about it.
This means you have to TELL NetBackup that you have cleaned the drive manually with 'tpclean -M <drive-name>'.
The tape shows 0 cleans because NBU has not done the cleaning - it does not know about your manual cleaning.
Best to have one or two cleaning tapes in the robot so that NBU can react and mount the cleaning tape when the TapeAlert is received from the drive(s).
11-20-2013 07:19 AM
Also bear in mind that the cleaning tape itself has a built in memory - and once it has been used up it simply wont work any more
So you have cleaned the drive - reset its status and the cleaning tape shows as zero .... but if the drive is not clean enough and the cleaning tape is used up netbackup will call it - get a reply that the cleaning tape is no good and will stop using the drive again
Let NBU do the cleaning and preferably start afresh with new cleaning tapes if possible