11-11-2013 11:25 PM
Hi,
I am trying to configure AIR with the help of commands.
please send me command sequence for AIR (auto image replication) for PureDisk based setting.
I required the command sequence for below doc.
Thanks in advance.
11-12-2013 04:44 AM
You are asking quite a lot here for someone to do all this for you - there are an awful lot of commands involved to do all of this.
As you have your process document and know the steps needed then work through each one in conjunction with the NetBackup Commands Guide : http://www.symantec.com/docs/DOC5182
The main commands involved will be nbemmcmd, nbdevconfig, bpstuadd
Hope this helps - maybe someone does have the free time to do all of this for you but i have my doubts
Good luck
11-12-2013 06:44 PM
Ok.
Thanks for your reply.
Could you please share command to add replication target on master server.
11-12-2013 10:25 PM
Why not simply use the GUI?
If you are not a consultant who needs to do this on a daily basis at multiple sites, I really don't see the need for commands and/or scripts.
I bet even Mark (who is a consultant and has configured this more than any other person that I know) is using the GUI. It is only a couple of short steps and clicks...
11-12-2013 10:37 PM
Hi Marianne,
Thanks for reply !
But i requried commands for Automation.
11-13-2013 02:44 AM
It will be nbdevconfig to do it but i haven't pinned down the latest command for it yet
This tech note indicates a new -setreplicationconfig switch but not many details and it doesnt recognise it on my 7.5 system
http://www.symantec.com/docs/HOWTO72710
You will have to keep digging or hope someone from Symantec has access to the latest commands