02-27-2016 12:25 PM
Hi everyone,
I had to restart the master server, but when the master server started, I found that only 2 drives were working of 4, my question is: what is the best option to startup or recognize the drives again, from command line?
thank you for you attention.
My library is HP MSL6480
NBv 7.6.1
/usr/openv/volmgr/bin/vmoprcmd -dp
PENDING REQUESTS
<NONE>
DRIVE STATUS
Drv DrivePath Status Label Ready
0 /dev/nst3 UP Yes Yes
2 /dev/nst1 UP Yes Yes
ADDITIONAL DRIVE STATUS
Drv DriveName RecMID ExtMID Wr.Enbl. ReqId Assigned Shared
0 HP.ULTRIUM6-SCSI.000 G629L6 G629L6 Yes 0 srvbackup No
2 HP.ULTRIUM6-SCSI.002 G628L6 G628L6 Yes 0 srvbackup No
# /usr/openv/volmgr/bin/vmoprcmd
HOST STATUS
Host Name Version Host Status
========================================= ======= ===========
srvbackup 761000 ACTIVE
PENDING REQUESTS
<NONE>
DRIVE STATUS
Drive Name Label Ready RecMID ExtMID Wr.Enbl. Type
Host DrivePath Status
=============================================================================
HP.ULTRIUM6-SCSI.000 No No No hcart3
srvbackup /dev/nst3 TLD
HP.ULTRIUM6-SCSI.002 Yes Yes G628L6 G628L6 Yes hcart3
srvbackup /dev/nst1 ACTIVE
02-29-2016 08:41 AM
do the following to see if the OS sees the devices
cat /proc/scsi/scsi
If you find all 4 drives there then check from netbackup
/usr/openv/volmgr/bin/scan
If that shows all 4 drives then run the device configuration wizard again
02-29-2016 08:41 AM
do the following to see if the OS sees the devices
cat /proc/scsi/scsi
If you find all 4 drives there then check from netbackup
/usr/openv/volmgr/bin/scan
If that shows all 4 drives then run the device configuration wizard again
03-04-2016 06:56 AM
to up drives
tpconfig -update -drive 4 -drstatus UP
03-05-2016 02:21 AM
03-05-2016 09:37 AM
Hi,
Please compare the output of the following commands,
tpconfig -l
tpautoconf -t
the above commands will show you the drives which are at OS level (tpconfig -l) and NetBackup level (tpautoconf -t)
Regards
Elango