cancel
Showing results for 
Search instead for 
Did you mean: 

How to check out of two drive path for single drive which path is chosen during backup by netbackup

MG11
Level 4

Hi,

If i have two drive path for a particular drive.
How i can check a particular stream has chosen which path for taking backup.
 

 

In the below log 6cbn was not working.. we got this info from var/adm/messges.
After that we made it down and triggered the backup it went succesful

So how to check if there are two paths for a drive which path netbacku pis using 

 

 Capture.PNG

1 ACCEPTED SOLUTION

Accepted Solutions

Will_Restore
Level 6

You can search for PATH in bptm logs.

View solution in original post

3 REPLIES 3

Will_Restore
Level 6

Use single path.  See this old thread:

https://www.veritas.com/community/forums/dual-port-tape-drive-multipathing#comment-10292381

 

MG11
Level 4

Hi Will,

 

Thanks for the info.I have further below queries 

For me the backup went fine till stream 13 and it failed for stream 14 with 24 error when i checked in var/adm/messages i found fatal error with drive path.
when i suspected there is some issue with this particular drive path so i made it doen and used thet other path i.e 7cbn and backup went fine.
So i have below questions.

1.The streams which were successful, did they used the other drive path i.e /dev/rmt/7cbn ?
2. Stream 14 failed, did it used drive path /dev/rmt/6cbn ?
3.Any log where i can check which drive path was used for which stream.

 

Regards
Martand Gupta

Will_Restore
Level 6

You can search for PATH in bptm logs.