10-15-2017 11:32 PM
I have problem on the NBU , after replace the autoloader an run the device wizard to reconigse the new library with new firmware version, then I run the test backup, it works. After schedule the backup , all job failed in error 96 or 800 on the policy, I check the robot it shows three robot arm then I remove those robot arm who show NONE on the console. i have no idea why did it happens when use the new firmware NBU , may I koow if there is problem on my side, please advice
10-16-2017 04:39 AM
Hello
I would have started with:
tpconfig -d
vmglob -listall
vmoprcmd
to gather details...
Then if any robot, drive is still there - remove these...
rerun device wizard.. ensure storage units are OK, etc and stop/start nbu
rerun all these commands to see if all is as requested... test backups...
10-16-2017 07:34 AM
Thank you Sir !
Let me try it tomorrow
12-03-2018 04:58 AM
It works?