Robot library is not defined in EMM

[Home_224]

I have problem on the NBU , after replace the autoloader an run the device wizard to reconigse the new library with new firmware version, then I run the test backup, it works.  After schedule the backup , all job failed in error 96 or 800 on the policy, I check the robot it shows three robot arm then I remove those robot arm who show NONE on the console.  i have no idea why did it happens when use the new firmware NBU , may I koow if there is problem on my side, please advice 

[quebek]

Hello

I would have started with:

tpconfig -d

vmglob -listall

vmoprcmd

to gather details...

Then if any robot, drive is still there - remove these...

rerun device wizard.. ensure storage units are OK, etc and stop/start nbu

rerun all these commands to see if all is as requested... test backups... 

[Home_224]

Thank you Sir !

Let me try it tomorrow

[Cedeguill]

It works?