cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted

Trouble with nbperfchk

Hi!

I have a issue with nbperfchk. My write test was successfull. I used the command nbperfchk -i zero: -o T:\test -s 80g -syncend.

Now I want to do the read test and use the command: nbperfchk -i T:\test -bs 1M -o NUL.

All i get in the console are the following lines:

9 MB @ 0.0 MB/sec, 0 MB @ 0.0 MB/sec, at 1382082483.

The last number counts up every line by 3, the rest stays the same. for over 2 hours now. 

Am I doing something wrong or is there a hardware/software issue?

Thanks for your help

1 Solution

Accepted Solutions
Highlighted
Accepted Solution!

Just found that nbperfchk was

Just found that nbperfchk was having this issue back in 7.5.0.6 & 7.6.0.1, from what I know it is fixed in 7.5.0.7 & 7.6.0.2.

View solution in original post

7 Replies
Highlighted

Try with this: nbperfchk -i

Try with this:

nbperfchk -i T:\test -bs 1024k -o NUL

Highlighted

i have tried it now... this

i have tried it now... this is what i get

 

nbperfchk.JPG

Highlighted

Strange.. I believe your

Strange..

I believe your command prompt is "run as administrator", isn't it?

What if you just try with C:\somefile.txt   (assume somefile.txt exists in C:\) ? 

Might want to check with Symantec support...

Highlighted

Hi Bublebeeman85, Sorry, I'm

Hi Bublebeeman85,

Sorry, I'm editing my earlier comment. But essentially you can try experimenting with different buffer size value, e.g. 4096k.

Cheers,

Wiriadi

 

Highlighted

Hello, i have the same issue.

Hello,

i have the same issue. Did you find a resolution ?

 

Highlighted
Accepted Solution!

Just found that nbperfchk was

Just found that nbperfchk was having this issue back in 7.5.0.6 & 7.6.0.1, from what I know it is fixed in 7.5.0.7 & 7.6.0.2.

View solution in original post

Highlighted

thanks for the update watsons

thanks for the update watsons