08-14-2017 07:31 AM
I need to know when (date and time) the tape pool volume has changed (new pool), even if a tape has not been written (0 Kb). Is there any command or is it even possible to see this somewhere in the GUI?
Solved! Go to Solution.
08-14-2017 07:50 AM
It is not possible to see this in the GUI.
Some changes to configuration are tracked by NBU auditing but I doubt that pool changes will be one of them.
You can run 'nbaudit' from cmd (in ...\netbackup\bin\admincmd) to see a list of changes that NBU has logged.
Other than that, the only other place where the change may have been logged will be in one of the volmgr\debug folders - but only if the log folders were created beforehand.
No idea which one, but probably one of these logs:
daemon, reqlib, tpcommand
(A list of volmgr/debug log folders can be found over here: https://www.veritas.com/support/en_US/article.TECH75805 )
08-14-2017 07:50 AM
It is not possible to see this in the GUI.
Some changes to configuration are tracked by NBU auditing but I doubt that pool changes will be one of them.
You can run 'nbaudit' from cmd (in ...\netbackup\bin\admincmd) to see a list of changes that NBU has logged.
Other than that, the only other place where the change may have been logged will be in one of the volmgr\debug folders - but only if the log folders were created beforehand.
No idea which one, but probably one of these logs:
daemon, reqlib, tpcommand
(A list of volmgr/debug log folders can be found over here: https://www.veritas.com/support/en_US/article.TECH75805 )
08-14-2017 10:57 AM
I did not succeed.
Equally grateful for the return Marianne.