03-31-2022 04:10 AM
03-31-2022 04:16 AM
I really do not know if there is limitation on flex, but I never install a master server with MSDP. BYO or appliance.
I had install 3 or 4 flex till now and I always separate master and media servers.
And I suggest you to do the same.
03-31-2022 02:14 PM
HI @sandreou
As indicated by @StefanosM running a MSDP server on the master is not a good idea (there are occasions where it is necessary, but in general avoid doing it). On the Flex as you have correctly read, it is not possible to create any storage pools on a master server instance, so you would need to have both a master and media server to run NetBackup from the Flex. The master of course could be run elsewhere.
Cheers
David
04-08-2022 01:40 AM
nice, thanks for the reply guys , but looks that when you create Master everything runs as expected and instance created , but when you try to create media server always get different errors such as :
Failed to obtained host ID-based certificate
Failed to determine CA type of the NetBackup domain
CA certificate fingerprint mismatch
this three new setups run with the same CA and i get that CA from master server that create before
its really annoying because its just a "simple setup"
04-11-2022 11:59 PM
Hi,
You are right, the correct way is to install 2 instances, one for master and a second for MSDP. I have deployed them several times with no issues. I usually copy the CA SHA-1 fingerprint from the master details in flex console. And I am afraid that for the certificate, if you have tried to deploy it several times you should create a reissue token on the administration console to recertificate the new instance.
Also, regarding best practices, you should check this white paper, there are some rules you should take care with flex deployment:
https://www.veritas.com/content/support/en_US/doc/NetBackupFlexAppliances_BestPractices
Regards,
Enrique
04-12-2022 02:58 AM
because that was new installation i delete the master and install again with separate media and looks that was the best solution, btw thanks for the white paper will be helpful for later installations
12-03-2023 09:16 AM
Required support for linking the Netbackup 10.3 on prem with flex 3.2 storage