11-29-2022 08:21 PM - edited 11-29-2022 08:24 PM
11-29-2022 08:41 PM
Hi @BobbyXu
First check that the services restart correctly - in particular the NetBackup Web Management Console".
If you are on Linux, then run the following two commands:
service netbackup stop
service netbackup start
Make sure everything starts.
David
11-29-2022 09:12 PM - edited 11-29-2022 09:17 PM
Thanks @davidmoline
I have tried you recommendations and it works.
May I know what is the cause of this can't possibly run this command after every restart
I am using RHEL 8.6 with nbu 9.1.0.1
I have tried multiple times of reinstalling but every time end up with the same result, that the reason why I am asking for help here.
11-29-2022 10:11 PM
Hi @BobbyXu
It is difficult to give you a reason why NetBackup isn't starting properly. By rights when you install NetBackup it should be configured to start on boot (what else is the server doing, what are the h/w specs?).
After a reboot are any NetBackup services running at all (can you show the output please)?
# /usr/openv/netbackup/bpps -x
NetBackup does not use systemctl but the older start-up method (maybe this is why on 8.6). Anyway check to see if it is enabled (the run levels listed as "on" - try this command:
# chkconfig --list
You should see lines for NetBackup (netbackup) and PBX Exchange (vxpbx_exchanged) required by NetBackup, something like this:
# chkconfig --list
Note: This output shows SysV services only and does not include native
systemd services. SysV configuration data might be overridden by native
systemd configuration.
If you want to list systemd services use 'systemctl list-unit-files'.
To see services enabled on particular target use
'systemctl list-dependencies [target]'.
netbackup 0:off 1:off 2:on 3:on 4:off 5:on 6:off
vxpbx_exchanged 0:off 1:off 2:on 3:on 4:on 5:on 6:off
Cheers
David
11-29-2022 10:30 PM - edited 11-29-2022 10:55 PM
Here u go.
11-30-2022 03:16 PM
Hi @BobbyXu
While the information is nice, there is no context and you have not provided all the output I requested (e.g. chkconfig --list).
The services shown look like everything is running okay, but is this after a reboot without any other intervention?
David
12-01-2022 04:20 AM
12-01-2022 07:16 AM - edited 12-01-2022 07:17 AM
Hi,
Netbackup 0:off 1:off 2:on 3:on 4:off 5:on 6:off
vxpbx_exchanged Netbackup 0:off 1:off 2:on 3:on 4:on 5:on 6:off
No intervention after reboot
12-03-2022 08:14 PM
Hi @BobbyXu
I can't see anything obviously wrong in what you have shown. Are there any other processes on the master server that want to use port 443?
David