I'm running RepExec on a healthy 1GB Ethernet link between two systems, they are both on the same switch. I can't get RepExec to use more than 3% of the available bandwidth. I'm not sure what else to check. I can run other programs and use a great percentage of BW. Throttling is set to 50% of a 1GB link.
The highest transfer rate I've seen is about 25 to 30 Mbps where it is allowed 500 Mbps. Is anyone else seeing better throughput? Ideas? I wanted to finish this replication locally then move it offsite where speeds will be at 8 Mbps.
RB