03-15-2019 11:56 AM
Hi all,
i have an issue on the networking configuration after starting the networking services in veritas system recovery 18 from system recovery disk. After I key in the IP address, click ok and then it hang for about 15 mins and prompt an error “ could not connect”.
I try to remove all the network cable before starting networking services,but it still same. I configure the IP address on one of the backup vlan nic port and it is teaming in the windows .
Do I need to configure the IP address on the unused nic port which is don’t have any teaming configuration in the windows?
hope that someone can help me on this issue.
thank you
Solved! Go to Solution.
03-18-2019 03:29 AM
Perhaps run CMD from the recovery disk, then try and use this method to assign the IP address:
http://wintech.sgal.info/2017/03/configure-static-ip-address-in-winpe.html
03-17-2019 11:28 PM
For me it sounds more like the driver for this nic is missing in the recovery disk.
03-18-2019 03:29 AM
Perhaps run CMD from the recovery disk, then try and use this method to assign the IP address:
http://wintech.sgal.info/2017/03/configure-static-ip-address-in-winpe.html
04-01-2019 08:45 PM
hi,
thanks for your reply, i can view all the nic in the backup exec