07-23-2015 12:30 AM
I used backup exec system recovery to convert virtual to physical ,
in the virtual server used BESR 2010 install agent and run backup all system and used SRD (symantec recovery disk) in the physical server and then after recovery the physical server is reboot after that the physical server cannot start up ,have the error "Windows failed to Start ......"
Please help me !!
damrongpol s.
07-23-2015 12:38 AM
More details needed in order to help you ....
07-23-2015 01:08 AM
1.Windows 2008 R2 std 64 bit
2.ESX 5.5
3.
4. Drive C:
and Physical H/W (HP DL360G5)
Best Regards and thank you.
damrongpol s.
07-23-2015 01:15 AM
ESX 5.5 is not supported with BESR 2010: http://www.symantec.com/docs/TECH137684.
Only drive C? Is the original server still available? If yes, can you check to see if it has a system reserved partition? If it does, you MUST back this up and restore it otherwise the restored server won't boot.
07-23-2015 01:50 AM
OK. thank you for your information and support
if I have a question , I come back again.
thank you so much.
07-23-2015 04:41 AM
now,
I used backup exec recovery 2013 R2, check sw compatibility is OK but the server is error
"Attempting Boot From CD-ROM
Attempting Boot From Hard Drive (C:)
BOOTMGR is missing
Press Ctrl+Alt+Del to restart
07-23-2015 05:13 AM
What about my earlier comment?
Only drive C? Is the original server still available? If yes, can you check to see if it has a system reserved partition? If it does, you MUST back this up and restore it otherwise the restored server won't boot.
12-01-2015 07:20 AM
this issue has been resolved.
thank you so much
12-01-2015 07:41 AM
Thanks for the update. So what was the solution?