About worldzfree

worldzfree · 10-10-2011

I have a user that cleaned out a few of their old exports from the file share on the DA server. The exports had completed properly and they didn't need the export data anymore. She said she just deleted the whole folder tree under the export name. ...

worldzfree · 06-29-2011

I have read the other topics about this message that is presented after running the Enterprise Vault Deployment Scanner and I understand that IPv6 is not yet supported. My question is that if IPv6 is enabled on the NIC (default 2008 R2 setting) will...

worldzfree · 03-30-2011

We recently upgraded our Vault environment to 8.0sp5 from 2007. I am trying to get the backup procedure to work properly but I need clarification from Symantec. We use Netbackup 7.x without the Vault Agent for Netbackup. This uses the bpstart and ...

worldzfree · 02-07-2011

I accidentally installed SMTP archiving when I setup a test box. How do I remove that component without uninstalling the whole Vault application off of the server?

worldzfree · 02-01-2011

We are moving to EMC Celerra for Vault partition storage. Our current configuration is SAN-attached NTFS drives in Vault 2007sp4. The end goal is to move the partitions to EMC Celerra front-end running CIFS. I was planning on following the followi...

worldzfree · 04-28-2011

i had this issue too. i had to force mailbox synchronizations to make it go away.

worldzfree · 04-01-2011

FreKac, In theory if I just run the one command to put the whole site into backup mode it should also put the index files in backup mode right? I just ran a test with the site backup mode powershell and then performed a get-indexlocationbackupmode...

worldzfree · 04-01-2011

i have seen that. until i got the clarification from the above post the following lines were sort of grey to me. "When selecting “Set Backup Mode” on Vault Stores or index locations at the site level (as shown in the previous screenshot), all Vaul...

worldzfree · 04-01-2011

Thanks for the clarification. Makes alot more sense now. Is it just more or is this no where in the Symantec's documentation? Thanks again.

worldzfree · 04-01-2011

I think I understand. So right now I have the following called during the bpstart. Set-VaultStoreBackupMode -Name 'SiteName' -EVServerName evsite -EVObjectType Site Set-VaultStoreBackupMode -Name 'Default Upgrade Group' -EVServerName evsite -EVObj...

VOX

User Statistics

User Activity

Event log stating DA cannot find the path to an old export

"At least one network connection on the Enterprise Vault server is IPv6-enabled"

Need official Symantec clarification on cryptic instructions to backup Vault 8.0

How to remove a vault component?

Moving partitions to EMC Celerra front-end??

i had this issue too. i had

FreKac, In theory if I just

i have seen that. until i

Thanks for the

I think I understand. So