I a currently working with a customer implementing HA/DR for SQL 2008 and EV9.
The customer needs to know why the VCS hadhelper account requires the following permissions
SECTION 2 - Required Rights
The account that is used by the HadHelper...
Hi all,
IHAC that has configured a central SPA (5 nodes non HA) in ESX4.1 (3 ESX Hosts) and has 80 remote office locations replicating to the central SPA.
Node breakdown as below
1 SPA, MBE,CR
2 CR,MBE
3 CR,MBE
4 CR
5 CR
Each node is configure...
During Puredisk replication (6.5) between two content routers, the power at the remote site to the PD node and its Storage was disconnected. After a restart the content router will not start and the following is logged in the spoold log file. Decembe...
Hi, I have just performed an upgrade from 6.2.1 to 6.5, all seems to be OK however when i run the DR Backup to Netbackup i get the following /Storage/log/spoold/storaged.log shows 1701 transactions pending and does not seem to be going down DR Backu...
Hi Guys, I am about to perform another 6.2.1 to 6.5 upgrade, however on the current system there is a problem with the CIFS gateway service. When i try to start it i get the following message 'aborted' and the service states "unknown" The following...
Hi there, Yes topology.ini was fine, I have just performed the upgrade to 6.5 and CIFS is fine now. I think it was down to a corrupt smbd.conf or nmbd.conf file. Thanks for the post.
Hi all,This is now resolved, For information the problem was down to the following.Puredisk License was registered on NBU Master, but NBU Master license was not registered on PD NodeThere was no reverse DNS Entry for the PDNODE, Once this was added t...
I am having the same problem, Everything is set up as per the admin guide, I have also applied the PDISK License key to the NBU Master to ensure that DATASTORE is licensed correctly, The complete error message i am getting is.Error: 3 : Failed to sta...