I currently have the issue as covered in the following article:
http://www.symantec.com/business/support/index?page=content&pmv=print&impressions=&viewlocale=&id=TECH87855
I am running Backup Exec 2010 R3 and note in the article that there are no pla...
Following an upgrade from Backup Exec 12.5 to 2010 the job rate has dropped from 1,367.00MB/min (136,049,876,814 Bytes) to 931.00 MB/min (140,469,660,443 Bytes).
Apart from the upgrade no further changes were made.
Is there any reason why the j...
I'm having problems getting Backup Exec 12 to work on a Windows 2000 Server SP4. The pre-install environment check displays a WMI warning 'An error was detected in WMI. This may cause the SQL Express installation to fail..'. I've continued with the i...
I have a similiar issue with the job rate falling following the installation of BE 2012 SP4 & Hotfix 217347.
Running on Windows Server 2003 SP2. Backing up to external Tandberg LTO-2 drive. The job rate prior to the installation of SP4 & Hotfix 217...
I have the same problem with my new SBS2011 server running Backup Exec 2012. RDX Drive is used. My media gets used then ends up in the 'Backup Exec and Windows NT Backup Media' Media Set so i can longer append to them.
I've read TECH192382 - is there...
Would you class a job rate of 915.00 MB/min as good?
Prior to the upgrade it was around 1367.00 MB/min.
Need to explain why to my boss and if there is anything that could be done to improve it.
Thing is i think the job rate is still good but need ...
Thanks Craig & Ken for your advice - i changed the drive settings as suggested which has made a small improvement but it is still not up to where we were before the upgrade was made. BE is fully patched and RAWS agent is not applicable in this setup....
Hi Craig - the settings on the tape drive hadn't changed.
I have a Tandberg TS400
Firmware 0376
Block size 64KB
Buffer size 64KB
Buffer count 10
High water count 0
Write single block mode & Write SCSI pass through mode selected.