OK here is a question I hope someone has an answer to. I have a MSL4048 LTO3 FC with 2 drives, Whats happening is after a few hrs of using both drives at the same time I will loose drive 2, Drive 1 stays on line. When I lose drive 2 there is no ...
I am looking for a way to change the location of the nightly database backup. I know you can change the location of the database but I do not see where to change the location of the backup of that database. If the drive goes down and the database...
CraigV, your solution was the closest. What we ended up doing was disabling polling all together. It took a lot more work then should have been required. It turns out that HP's fiber agent and some of the other HP agents caused excessive TUR's as w...
we had a similar issue, if you run tracer.exe in the bexec directory, start it and let it run while the jobs are running, Look for excessive TUR's, if you do see the TUR then you might want to verify that the symantec drivers are loaded and are curre...
The libray is connected directly to a Qlogic dule port HBA, I can run a backup to drive 1 for 24hrs w/o error, within 2 hrs of startign nother job to drive 2 it will go offline and take drive 1 offline with it. I have been speakign with HP about...
I know this is an old post but. I recently had the same issue, What you will need to do is go into Bexec and rerun the device wizard under tools>wizards. It will redetect the new device, You can then go into devices and select remove for the old d...